Frigidaire Washing Machine Repair in Toronto — Leaking water

• Door boot (bellows) tear is the #1 Frigidaire front-load leak. On the Affinity/FFFW lineage the boot 134515300 is the no-light-hole door variant (the 134728400 is the version with a light window, so the boot is selected by your tub's door style, not by chronology). It typically splits at the 6-o'clock fold where coins and grit pool, so water drips to the floor on the wash fill. Overloading accelerates the tear; we replace the boot rather than patch it.
• Drain pump 137221600 leaks from the volute or the red anti-backflow flapper seat, not just the famous E20/E21 drain blockage. When the pump body cracks or the hose clamp at the pump corrodes, you get a slow puddle under the front-left foot during drain. Same part that the E20 cleanout exposes -- if the housing is wet, it is replaced, not just cleared, and the red flapper is not sold separately from the pump.
• Tub-to-pump hose 134455900 splits or pops its spring clamp. This is the leak that only appears during the high-speed drain/spin when the hose pressurizes -- dry on fill, wet on spin. We never cut and re-stretch this hose (it ruptures later); the whole hose gets replaced and both clamps re-seated.
• Outer tub seal / drive-shaft gasket 134146100 leaks from the centre rear of the tub down the spider -- the watertight gasket around the drive shaft between outer tub and spin basket. Presents as water tracking down the rear of the cabinet and is the leak that, left alone, drowns the rear bearing.
• Rear tub & bearing kit 131525500 is the consequence fault: once the 134146100 tub seal weeps, water sits in the rear bearing and it goes from a leak complaint to a spin roar. On high-mileage Affinity units we quote the bearing+seal together because pressing the bearing alone rarely pays -- it is an economics conversation, not a quick part.
• Water inlet / fill valve 134211400 leaks or won't shut off, overfilling the tub so water escapes the door -- the leak that mimics a boot tear but is actually a fill fault. Hard-water scale on the solenoid seat keeps it cracked open; the same valve is the cure for the E11 fill-timeout family already on this platform.

Frigidaire leaking water in Toronto — the local specifics

• The recurring Toronto pattern: an Affinity/FFFW owner reports 'water on the floor' that is really a boot 134515300 split at the 6-o'clock fold -- we routinely fish coins and a bra wire out of the same bellows that tore it. The trickier recurring call is the leak that only shows on spin (a split tub-to-pump hose 134455900) versus the one that shows on fill (boot or overfilling 134211400 valve), and we diagnose by watching which part of the cycle puddles before quoting.
• We roll to Frigidaire leak calls carrying the 134515300 door bellows (confirming the no-light-hole vs light-hole door style before fitting), the 137221600 drain pump, the 134455900 tub-to-pump hose and clamps, and the 134211400 fill valve -- the four parts that close out most one-visit leaks. The 134146100 tub seal and 131525500 rear-tub/bearing kit are confirmed by teardown first, then order-in same-week from the GTA channel.

For the full Frigidaire washing machine module — every fault, part number and code — see Frigidaire washing machine repair in Toronto, and for the same fault across all brands the washing machine leaking water guide.