How much does Kenmore dryer repair cost in Brampton?
Kenmore dryer repair in Brampton typically runs $250–$400 all-in, depending on the fault. The most common Kenmore call-out is not heating ($250–$390). Every visit starts with a flat $149.95 diagnostic, credited 100% toward your repair, and repairs are backed by a warranty.
- Diagnostic
- $149.95, credited 100% toward your repair
- Warranty
- on parts & workmanship
- Availability
- Same-day & next-day appointments available
Prices in CAD for Brampton; typical ranges — your exact quote is confirmed on-site before any work. Updated .
Most Kenmore dryer faults in Brampton come down to a handful of parts — and the majority are worth repairing rather than replacing a 10–13 years appliance. Our certified technicians carry the common dryer parts on the van, so most Brampton jobs are diagnosed and fixed in a single visit.
Kenmore Dryer repair costs in Brampton
Honest, all-in ranges for common jobs. Every visit starts with a flat $149.95 diagnostic that is credited 100% toward your repair — so you never pay it twice.
| Problem | Parts | Labour | All-in |
|---|---|---|---|
| Not heating | $20–$140 | $120–$190 | $250–$390 |
| Drum not spinning | $20–$130 | $130–$200 | $260–$400 |
| Loud or squealing | $20–$120 | $130–$190 | $260–$380 |
| Diagnostic (credited to the repair) | $149.95 |
Ranges are estimates for common Brampton jobs; your exact quote is confirmed on-site before any work begins. Prices in CAD, updated .
How your repair works
Four simple steps, no surprises.
Book
Call or request a callback. Same-day & next-day appointments available.
Diagnose
A flat $149.95 diagnostic pinpoints the real fault.
Approve
You get an upfront all-in quote first — diagnostic credited 100% toward your repair.
Repaired
Fixed with OEM parts, backed by a 90-day warranty.
Common Kenmore Dryer problems & what we check
Tap any problem for the likely causes, what is safe to check yourself, and what it costs.
Not heating
Not heating: The drum turns but the air is cold and clothes stay damp after a full cycle.
Also described as: no heat, clothes still wet, runs but cold
Likely causes
- Blown thermal fuse — usually from a clogged vent overheating (Most common)
- Failed heating element (Common)
- Faulty thermostat or thermistor (Common)
- Gas models: failed igniter or gas-valve coils (Occasional (gas))
✔ Safe to check yourself
- Clean the lint filter and check the exterior vent flap opens — a blocked vent is the #1 root cause and trips the fuse.
- Confirm the dryer isn't on an air-only / eco setting.
✖ Leave to a technician
- Heating element, thermal fuse and any gas component are technician jobs (electrical / gas safety).
Related: Drum not spinning · Loud or squealing
Drum not spinning
Drum not spinning: The dryer powers on and may hum, but the drum doesn't rotate.
Also described as: drum won't turn, hums but no spin
Likely causes
- Broken drive belt (Most common)
- Failed drum roller, idler pulley, or worn bearing (Common)
- Failed drive motor (Occasional)
- Broken door switch (won't start at all) (Occasional)
✔ Safe to check yourself
- Confirm the door closes fully and the start button is held briefly.
- Listen: a hum with no spin usually points to the belt or motor.
✖ Leave to a technician
- Belt, roller and motor replacement require opening the cabinet — technician job.
Related: Loud or squealing · Not heating
Loud or squealing
Loud or squealing: A squeal, grind, or rhythmic thump that builds as the drum turns.
Also described as: squeaking, grinding, thumping, rumbling
Likely causes
- Worn drum rollers or idler pulley (Most common)
- Worn drum glide / slide bearings (Common)
- Failed blower wheel or a foreign object in the blower (Occasional)
✔ Safe to check yourself
- Check pockets for coins/objects that may be in the drum or blower.
- Confirm the dryer is level.
✖ Leave to a technician
- Roller, pulley and bearing replacement is a technician job.
Related: Drum not spinning
Kenmore dryer parts we stock
Kenmore is a Sears RETAIL BADGE, not a manufacturer — the real maker is decoded from the FIRST 3 DIGITS of the model number on the door/cabinet tag. There are no "Kenmore" part numbers: the parts ARE the donor maker's parts. The dominant Kenmore dryer donors are 110.=Whirlpool-built (29" rear-fuse + 27" Duet platforms — blown thermal fuse from a clogged vent is THE no-heat story), 796.=LG-built (Flow Sense d80/d90/d95 vent codes), and 417.=Frigidaire/Electrolux-built (the Kenmore Elite "417 series" — E64 open-heater is the signature). We decode the FULL model and serial before the visit so the right donor van kit is on board, not a second trip.
Signature Kenmore faults
- 110. Whirlpool-built: thermal fuse blown / element open — tumbles but no heat; root cause is almost always a clogged vent run that cooked the fuse (most common (110. = largest GTA installed base))
- 796. LG-built: Flow Sense exhaust restriction + thermistor faults — machine derates/extends cycles or won't heat; display shows d80/d90/d95 or tE1 (common (Kenmore Elite 796.))
- 417. Frigidaire/Electrolux-built: heater open circuit — no heat with E64 stored; element reads open on a meter (common (Kenmore Elite 417. series))
- Drum rollers / belt / idler wear (all donors) — thump, squeal, or drum free-wheels while motor runs (common — donor-specific kit numbers)
| Part | OEM number | Price band |
|---|---|---|
| Whirlpool-built (110.) thermal fuse, 196F/91C | 3392519 (WP3392519 / PS11741460) | $15–$30 |
| Whirlpool-built (110.) heating element, 240V/5400W | 8544771 (WP8544771 / PS11746337) | $70–$130 |
| Whirlpool-built (110.) thermal cut-off kit | 279973 (AP3094323) | $30–$55 |
| LG-built (796.) poly-V drive belt | 4400EL2001A (PS3522928) | $20–$40 |
| LG-built (796.) exhaust thermistor | 6323EL2001B (PS3529026) | $20–$40 |
| Frigidaire/Electrolux-built (417.) heating element, 240V/5500W | 134792700 (AP4368653 / PS2349309) | $70–$130 |
Error codes we see on Kenmore dryers
- 110. AF
- Whirlpool-built: airflow restriction — clean the FULL vent run, not just the lint screen
- 110. F01 / L2
- Whirlpool-built: F01 main control board internal short; L2 one 240V leg down (breaker/cord check first)
- 796. d80 / d90 / d95
- LG-built Flow Sense: 80/90/95% exhaust blockage — vent service, usually not a parts job
- 796. tE1
- LG-built: thermistor (temperature-sensor) open-circuit fault
- 417. E64
- Frigidaire/Electrolux-built: heater open circuit — test element 134792700 for continuity
Why homeowners across Brampton call us
Repairs are carried out by our certified technicians — Appliance Repair Near is a Red Seal certified, 313A Licensed, TSSA Certified, ODP Certified company — backed by $2,000,000+ general liability insurance and a 90-day workmanship warranty on every job.
Red Seal technician
Work done by a vetted, certified technician — not a rotating subcontractor.
Licensed & gas-certified
313A refrigeration licence and TSSA gas certification for safe, code-correct repairs.
$2,000,000+ insured
Fully insured for general liability, so your home is protected during the repair.
90-day warranty
Parts and workmanship are warrantied — if it's not right, we come back.
OEM parts on the van
Common parts are stocked, so most jobs are completed on the first visit.
Upfront pricing
A flat $149.95 diagnostic, credited 100% toward your repair, and a quote before any work.
What our credentials mean for you
- Red Seal Certified
- The interprovincial standard for skilled trades — a journeyman who passed the national appliance-service exam.
- 313A Licensed
- Ontario's refrigeration & air-conditioning systems mechanic licence — legally required to work on sealed cooling systems.
- TSSA Certified
- Technical Standards & Safety Authority gas certification — qualified to work safely on gas appliances.
- ODP Certified
- Ozone Depletion Prevention certification — licensed to handle refrigerants responsibly and to code.
Repair or replace your dryer?
A simple rule of thumb: if the repair costs more than half the price of a comparable new unit and the appliance is near the end of its life, replacement may make more sense.
A dryer typically lasts – and costs $800–$1,500 to replace — so most faults under about $450 are worth fixing. We'll always tell you honestly when a repair isn't worth your money.
Keep your dryer running
Simple habits that prevent the most common Brampton repairs.
- Clean the lint filter before every load.
- Have the full vent run (wall to outside) cleared once a year — the top fire-prevention step.
- Don't overload the drum; it accelerates roller and belt wear.
- Check the exterior vent flap opens freely and isn't blocked by lint or snow.
Servicing Dryers across Brampton
Local water: Region of Peel — South Peel Drinking Water System, Lake Ontario source via the Lakeview and Lorne Park water treatment plants; hardness 120–130 mg/L as CaCO3 (7.0–7.6 grains/US gal) in 2024: moderately hard. The same moderately-hard Lake Ontario water as Mississauga and Toronto — the water itself is not the Brampton difference. What differs is the housing: big suburban kitchens run long concealed dispenser lines that scale and kink, so a "slow water / small ice" call here is as often the supply line as the inlet valve. Same 6-month filter habit; more line inspections.
Homes here: Detached-and-townhome suburb: single-detached houses are about 53% of Brampton's roughly 182,000 occupied private dwellings (2021 Census), with row/townhouses (~13%) and semis (~14%) making up much of the rest and apartments around 21% — large 1990s–2010s subdivision kitchens with French-door and side-by-side fridges, plus long concealed water-line runs behind cabinetry. Multi-generational households are common here, so secondary kitchens and second fridges (often in the garage or basement) are a frequent service reality.
Parts & timing: Common parts typically next-day across Brampton; same-day when the route passes a Mississauga/Brampton distributor branch.
Disposal & refrigerant: Peel Region does not collect large appliances at the curb. A retired fridge, stove, washer or dishwasher goes to a Peel Community Recycling Centre (large appliances and scrap metal accepted free of charge), is donated if it still works, or leaves with the retailer when the new unit is delivered. Refrigerant must be recovered by an ODP-certified technician before any fridge, freezer or AC is scrapped (O. Reg. 463/10; Federal Halocarbon Regulations, 2022).
Coverage: City of Brampton inside Peel Region — from Bramalea and Heart Lake across Springdale, Castlemore and the Gore, out to Mount Pleasant, Credit Valley and Churchville on the west side.
Towers & condos: Overwhelmingly ground-level detached and townhome access with driveway parking; the handful of newer Downtown and Hurontario-corridor towers follow the usual condo service-elevator booking.
Sources: municipal water quality report · appliance disposal rules. Facts verified 2026-06-13.
More appliance repair in Brampton
Other appliances
Nearby cities
Frequently asked questions
Why is my dryer not heating?
Why won't my dryer drum spin?
Why is my dryer loud or squealing?
Do you charge for the diagnostic?
How soon can you come out?
Are you licensed and insured?
Do you use genuine parts?
Do you service Kenmore dryers?
Need your Kenmore dryer fixed in Brampton?
Same-day & next-day appointments available. Flat $149.95 diagnostic, credited 100% toward your repair, and a 90-day warranty on every repair.
Call (647) 490-7878